PixelPro GXi Series
ZN1-D4NMZ43L Installation Guide
03-2014-B
7
Opener
4. INSTALLATION
4.1. Installing the camera
How to remove the dome cover
Remove the dome cover with the opener included in the package like the image
below.
Caution
!
To prevent products from damage, place the camera on stable and non-vibrating
surfaces If the stability is in doubt, consult safety personnel for reinforcements,
and then proceed with the installation.
1)
Place the installation template (outline
shown on the next page) included in the
package on the desired installation surface.
2)
Drill holes in correct positions based on
the template paper, and insert anchor
blocks into the holes.
3)
Remove the dome cover with the opener
included in the package.
4)
Make sure the necessary cables including
a LAN cable and a power cable are properly
connected to the camera.
*It is recommended to install the ferrite
core provided in the package on the MCX
cable to minimize high frequency noise
level. Please refer to the note on the next
page for the detail.
5)
Place the camera on the surface and
match the alignment holes with the inserted
anchor blocks.
6)
Tighten the anchor blocks with screws.
7)
Adjust the angle of the camera. Refer to
4.2.Adjusting angle of the camera
for the
detail.
8)
Attach the dome cover on main body and
push it toward main body till a “tick” sound
is heard.
Note
i
1)
Insert the tip of the opener in the groove.
2)
Give a little snap on the opener toward the upper right
direction. Then, the dome cover will be easily detached.
