PixelPro GXi Series
ZN1-D4FN7 Installation Guide
03-2014-A
7
4. INSTALLATION
4.1. Installing the camera
Caution
!
To prevent products from damage, place the camera on stable and non-
vibrating surfaces If the stability is in doubt, consult safety personnel for
reinforcements, and then proceed with the installation.
1)
Place the installation template (outline
shown on the next page) included in the
package on the desired installation surface.
2)
Drill holes in correct positions based on
the template paper, and insert anchor
blocks into the holes.
3)
Make sure the necessary cables including
a LAN cable and a power cable are properly
connected to the camera either thru the
ceiling or thru the groove around the
mounting plate.
4)
Place the camera body and match the
alignment holes with the corresponding
anchor blocks and hold against the
mounting surface.
5)
Tighten the anchor blocks with screws.
6)
Adjust the angle and focus of the camera.
Refer to “
4.2.Adjusting the angle of the
camera
”
and
“4.3. Lens Focus Adjustment”
for more details.
7)
Attach the dome cover on main body and
push it toward to the main body till a “tick”
sound is heard.
