UP (1)
the motor lifts the rolling shade/awning up
STOP (2)
the rolling shade/awning stops
DOWN (3)
the rolling shade/awning goes down
Prog-TX (4)
program the transmitter
1
3
2
4
ON
1
2
3
1
2
3
Prog-TX
(4)
Prog-TX
(4)
1
2
Prog-TX
(4)
Option 1
Option 2
CONNECT POWER TO THE MOTOR
PROGRAMMING A TRANSMITTER
ADDING A NEW TRANSMITTER
1
Press and hold
PROG-TX
button on the back of
transmitter till the motor starts moving
2
Check the motor rotation then release
PROG-TX
button (the motor stops)
3
Within 5 seconds, press the corresponding button
(
UP
if the motor turns upwards or
DOWN
if the
motor turns downwards)
Transmitter is now programmed
1
Press and hold
PROG-TX
button on the back of the
transmitter already paired till the motor starts
moving in one direction
2
Release
PROG-TX
button (the motor stops)
3
Within 5 seconds, press the corresponding button
on the new transmitter being added
Additional transmitter is now added
CHECKING / CHANGING DIRECTION
1
Press
UP
or
DOWN
the motor goes
UP
or
DOWN
accordingly, otherwise to change direction of
operation:
2
Press and hold
PROG-TX
button on the back of
transmitter till the motor starts moving
3
Press
STOP
: The motor makes a brief jog. Direction
of the motor has been reversed
IMPORTANT: the change of direction of operation
must be performed before initiating limit setting
procedure otherwise limits must be reset
DELETING A TRANSMITTER OR A CHANNEL
Using the transmitter to be deleted press and hold both
Prog-TX
and
STOP
buttons till the
motor makes a small jog
Only the transmitter used for this procedure has been deleted from motor memory
RESET TRANSMITTER MEMORY
(DELETING ALL THE TRANSMITTERS OR CHANNELS
OR SENSORS)
Option 1 - Using a programmed transmitter
Press and hold both
Prog-TX
and
STOP
buttons for at least 15 seconds:
as confirmation feedbacks the motor makes first a brief jog and after 5
seconds an additional long jog
Memory is now empty
Option 2 - Using a new transmitter without ID (not paired).
1
Switch the motor power supply OFF. Then switch it ON.
2
Within 8 seconds, using any Gaposa transmitter, press and hold both
Prog-TX
and
STOP
buttons until the motor makes a long jog
Memory is now empty
ON
OFF
