6
1
1
2
2
3
6. ADDING TRANSMITTERS
7. CHECKING / CHANGING DIRECTION
Press
UP
or
DOWN
the motor should go
UP
or
DOWN
, otherwise to change the motor direction:
Press and hold the
PROG-
TX
button on the back of
transmitter
ALREADY PAIRED
until the motor starts moving
Check the motor rotation
then release the
PROG-TX
button (the motor stops)
Press and hold the
PROG-TX
button on the
back of transmitter until the motor starts
moving
Within 5 seconds, press the
corresponding button (
UP
if the
motor turns upwards or
DOWN
if
the motor turns downwards)
on
the new transmitter that needs to
be programmed
Press
STOP
: The motor makes a brief jog. Direction of the
motor has been reversed.
IMPORTANT: change direction must be performed before
starting limit setting otherwise limits must be reset
1
2
4
3
5
Run the motor to an intermediate position
inbetween the two desired limits. The
motor needs to move in the direction
of the limit in order for the limit to be
properly set.
Press and hold the
PROG-FC
button on the back of transmitter
until the motor makes a brief jog.
Note: during “programming
mode” the operations are in
“deadman control” (The
UP
and
DOWN
buttons must be held
down inorder to move the motor)
Note: Accurate limit setting can be performed when UPWARD or DOWNWARD by pressing the
PROG-FC
button
a second time: the motor then moves slowly in steps towards to the desired limit. Always press
STOP
button
to set the limit position
Press and hold the
UP
button and run
the motor to the
desired
UP
limit
position
Press and hold the
DOWN
button and
run the motor to the
desired
DOWN
limit
position.
Press
STOP
to set the
UP
limit position. The
motor makes a brief jog
to confirm
Press
STOP
to set the
UP
limit position. The
motor makes a brief
jog to confirm.
8.
LIMIT
SWITCH SETUP
ALWAYS SET THE
UP
LIMIT
FIRST.
