SETTING THE LIMITS INDIVIDUALLY
(Sec. 5)
If the limits need to be changed after the initial limit setting
procedure, it is possible to change the limit positions individually.
One limit can be set without the other limit needing to be set. The
motor can be in any postion to initiate the procedure.
TO CHANGE THE
UP
LIMIT
:
1
From any point between the existing limits, press and hold both
the
LIMIT
button and the
UP
button until the motor makes a brief
jog.
Note: during “limit setting mode” the operations are in
“deadman control” (The
UP
and
DoWN
buttons must be held
down inorder for the motor to move.)
2
Press and hold the
UP
button until the desired new
UP
limit is
reached.
3
Press the
SToP
button to set the limit. The motor makes a brief jog
to confirm. The new
UP
limit is set.
TO CHANGE THE
DoWN
LIMIT
:
1
From any point between the existing limits, press and hold both
the
LIMIT
button and the
DoWN
button until the motor makes a
brief jog.
Note: during “limit setting mode” the operations are in
“deadman control” (The
UP
and
DoWN
buttons must be held
down inorder for the motor to move.)
2
Press and hold the
DoWN
button until the desired new
DoWN
limit is reached
3
Press the
SToP
button to set the limit. The motor makes a brief
jog to confirm. The new
DoWN
limit is set.
SETTING THE LIMITS
(Sec. 4)
IT IS MANDATORY TO SET THE “UP” LIMIT
FIRST EVERY TIME
Run the motor to an intermediate position inbetween the two
desired limits. The motor needs to move in the direction of the
limit in order for the limit to be properly set.
1
Press and hold the
LIMIT
button on the back of transmitter until
the motor makes a brief jog
Note: during “limit setting mode” the operations are in
“deadman control” (The
UP
and
DoWN
buttons must be held
down inorder for the motor to move.)
2
Press and hold the
UP
button and run the motor to the desired
UP
limit position.
3
Press the
SToP
button to set the
UP
limit position. The motor
makes a brief jog to confirm.
4
Press and hold the
DoWN
button and run the motor to the
desired
DoWN
limit position
5
Press the
SToP
button to set the
DoWN
limit position.
The motor makes a brief jog to confirm.
Note: Accurate limit setting can be performed by pressing the
LIMIT
button a second time: the motor will then will reduce
its output speed, moving slowly in steps towards the desired
limit. Always press the
SToP
button to set the limit position.
4
5
1
1
2
2
3
3
3
2
1
