28 Installation and operating instructions
10.
Initial operation
10.5
Express programming
Advice:
For proper initial operation of the operator system, the express programming procedure must be carried out.
This applies for the initial operation and after resetting.
When programming the OPEN and CLOSED door positions, the reference point must be passed.
Preconditions
The following conditions must be assured before express programming can commence:
- The door must be in the CLOSED end position.
- The carriage must be connected up.
The controls are programmed using the plus (+), minus (-) and (P) buttons. If no buttons are pressed within 120 seconds while in
programming mode, the controls revert to operating mode. A corresponding message is displayed.
Reference:
The messages are explained in Section 12.
Legend:
LED on
LED pulses
Factory default setting
LED off
LED flashes quickly
LED flashes quickly
–
Not possible
www.thegaragedoorcentre.co.uk
0800 525 442
www.thegaragedoorcentre.co.uk
www.thegaragedoorcentre.co.uk
0800 525 442
www.thegaragedoorcentre.co.uk