ITEM #05739 Rev B
14
Garaventa Genesis Screw Drive
Preventive Maintenance Inspection
To Be Performed At Least Once Each Year
Name_________________________________________
Date: ______________________
Address: ______________________________________
Shaftway:
θ
Enclosure:
θ
______________________________________________
Serial No.: __________________
______________________________________________
Hours on Counter: _____________
Location:______________________________________________________________________
Mast Cables
θ
Check all bolts securing mast rails.
θ
Check the Traveling cable for wear.
θ
Check the condition of the drive belt.
θ
Check all cables are securely attached.
θ
Check Motor Belt Tension. Adjust if necessary.
θ
Check all bolts securing Motor.
Platform
θ
Check bolts securing Top & Bottom bearing.
θ
Check Mast Tieback Bracket Fasteners.
θ
Ensure the platform cannot be rocked
θ
Check 4 Load Wheels are secure.
excessively. Shim if necessary.
θ
Check the drive nut for excessive play.
θ
Check for evidence of rubbing the shaftway.
Max. 1/2 mm Deflection. Replace as required
If so, what corrective action is required to
& Torque drive nut assembly to specified value.
correct.
θ
Check the safety nut.
___________________________________
θ
Check Lubricator has sufficient grease capacity.
___________________________________
% Remaining (approx.)___________________
___________________________________
θ
Confirm the Motor Running Amperage.
θ
Load ______________________________
θ
No Load ______________________________
θ
Check Track/Rollers for dirt, damage & cracks.
Control
θ
Lubricate upper & lower bearings.
θ
Check all the control buttons for function.
Safety Device
θ
Check the key switches.
θ
Check the interlocks for function.
Doors & Gates
θ
Check the nut safety switch
θ
Check the service key.
θ
Check the door and gate closers.
θ
Check the limit switches for platform stopping
θ
Check the hinge bushings for wear or damage.
position.
θ
Check the door/gate for interference with the
θ
Check the final limit switches.
frame.
θ
Check the Alarm.
Battery & Lights
Clean Up
θ
Is the battery charged.
θ
Remove excess grease from drive nut
θ
Do the platform lights work.
assembly and inside mast.
(Replace light bulbs as necessary.)
θ
Clean out any dirt and dust from the shaft base
area.
θ
Check for water in the shaftway pit.
θ
Clear the pit drain, if fitted.
θ
Clean up any marks or finger prints on panels.
Note any signs of corrosion, take photos and report to Garaventa Lift.
Refer to your Genesis Service Manual for further information.
