VEHICLE LOADING RAMP
Stair-Trac can easily be loaded into a van or a car trunk by using the Vehicle
Loading Ramp.
The Ramp was designed to support the Drive Frame only, and is not capable of
supporting Stair-Trac with a passenger.
1. Place the hook end of the Ramp over
the edge of the trunk lid or van bumper.
2. Line up the front of the Drive Frame
with the Ramp.
3. Remove the Wheelchair Support Handle.
4. Use the Operating Switch to make the Drive Frame crawl up the Ramp until it
is balanced over the top edge of the Ramp.
5.
(a) Cars:
Tilt the front of the Drive Frame into the car trunk. When the tracks rest on the
trunk floor, swing the back of the unit into the trunk, using the Operating
Switch located on the Drive Frame to position Stair-Trac as required.
5.
(b) Vans or wagons:
Tilt the front of the Drive Frame onto the vehicle floor and use the Operating
Switch located on the Drive Frame to move it into the vehicle.
6. Place the Wheelchair Support Handle upside down on the top of the Drive
Frame. Refer to “Storage” (page 12).
-16-