50
Via Leonardo da Vinci, 32/B
36034 Malo (VI) Italia
Operation and maintenance manual
Rev. 01/18-GB
TZ FIBER 540E / 630E / Conveyor-E
load by driving the machine in reverse, with the
toothed disc raised (see Fig. 5 / A) and taking
care to correctly load the loading ramps. After
loading the machine, fasten the machine with
suitable tie-rods to the anchor points of the load-
ing platform.
3.2.2 LOADING WITH CRANE OR
BRIDGE CRANE (Fig. 5/B)
If the machine is loaded or unloaded on or from
a transport plane, with a crane or a bridge crane,
move the machine by hooking it, with tie rods or
pre-arranged chains, at the points indicated for this
purpose, as illustrated in figure 5/B.
- Ensure that the area in which you make the
load has compact soil and is flat and dry.
- The platform on which you want to load the ma-
chine must be perfectly level to avoid possible
movement.
- Check that the loading platform is not damaged.
Should the platform appear insecure, too weak
or unstable, do not load the machine.
Fig. 5/B - Attachment points for the lifting of the machine with a crane or bridge crane
- Check that both the loading equipment and the
means of transport are in good condition and
suitable for the load.
- After loading the machine and loosening the
tie rods or chains that were used to lift it, fix the
machine with the suitable tie-rods to the anchor
points of the loading platform.
DANGER
After transport and before releasing the ma-
chine from all constraints, verify that the status
and position of the machine does not consti-
tute a risk.
Then remove the ropes, strains and proceed to
the discharge with the same means and methods,
used for loading in reverse.
WARNING
The manufacturer declines any liability for any
accidents which occur during loading and un-
loading of the machine and its various compo-
nents, due to the means of transport.
