Page 2 of 3 P/N 443560819360 Rev B
INSTALLATION INSTRUCTIONS
PUREFORM GEN. 2 –
P26/P34 WALL/SURFACE MOUNT (WS)
REQUIRED TOOLS:
9/16" SOCKET/OPEN
‐
END WRENCH & #2 PHILLIPS
‐
HEAD SCREWDRIVER
STEP 2: INSTALL SQUARE POLE ADAPTER (SPA)
Remove adhesive film from SPA and secure the adapter over
the mounting holes on Wall Box. Using the
3/8"‐16
x 2" hard-
ware provided,
install (1x) bolt, split washer and washer into the top threaded
hole of the wall box.
DO NOT TIGHTEN ALL THE WAY.
Leave
approx. a 1" gap to hang luminaire.
STEP 1: SECURE WALL BOX TO MOUNTING SURFACE
Wall mounting bracket is secured to wall with 3/8" studs or bolts
(Supplied by others).
The installer shall assure that structural members are present in
the wall with a sufficient safety factor to anchor mounting hard-
ware and support a luminaire weight up to 30 pounds for the
P26 and 37 pounds for a P34.
Refer to page 3 (
Figure 1)
for mounting hole pattern.
STEP 4: MAKE WIRE CONNECTIONS
Once luminaire is installed and hardware is
properly
torqued
, make supply wiring connections according
to the appropriate wiring diagram.
* 0‐10
V AND OVERRIDE WIRES OPTIONAL
* WIRE NUTS SUPPLIED BY OTHERS
* CONDUIT SUPPLIED BY OTHERS
STEP 3: INSTALL LUMINAIRE
Loosen (2x)
#8‐32
retained screws that secure the door
to the luminaire. Lower door and hang luminaire over
top mounting bolt using the key slot feature on the
back of the arm. Ensure that the washers remain on
the inside of the luminaire. Install the remaining
3/8"‐
16 x 2" bolt, split washer and flat washer into the lower
mounting slot of the luminaire.
Torque mounting hardware to 20ft
-
lbs.
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio of Signify
which information may be subject to change. No representation or warranty as to the accuracy or completeness of the
information included herein is given and any liability for any action in reliance thereon is disclaimed. The information
presented in this document is not intended as any commercial offer and does not form part of any quotation or contract.
All trademarks are owned by Signify Holding or their respective owners.
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
