38
39
www.Deuba24online.de
www.Deuba24online.de
•
B:
Material to be cut is pushed backwards
•
C:
blade drum does not rotate.
Note:
Before changing
blade drum has come to a
working speed.
Noise disturbance!
Work
with the product is not allowed
during customary rest periods.
•Cut up organic garden residues may be used as
-
ly degradable material such as leaves, branches
and grass into the feed hopper (1) in measured
•Cut material can be collected in a container
block the feed hopper (1).
•Alternate between twigs and garden rubbish
that has been stored for several days and is thus
limp and damp. This prevents the blade drum
from blocking.
for the chipper and should be composted.
Chipping
DANGER! Risk of injury!
Overloading caused, for exam-
ple, by a blocked blade drum
or material that is too thick will
cause the product to come to a
motor switches
off
the power
-
tect the motor from damage.
Wait at least one minute, then
switch (5) to reverse and then
press the On/Off switch (6).
Note:
The product has a
– Plug the power supply cord into a outlet.
Figure 3
– Press the On/Off switch (6).
– The product starts.
•
A
•Before new material is fed in, heavily branched
material with leaves must be completely cut up.
•Heavy material or branches will cause the
no breaks. Pull the material out by hand a short
way in order to counteract this problem, or use
•Carefully inspect the material to be cut. The
product may become seriously damaged from
stones, nails or similar objects.
damaged or blunt blades. In this case, replace
blades.
Removing blockages
Figure 4
– The blade drums rotates backwards and releas-
es the trapped material. You may need to press
free up the blockage.
– In the event of stubborn blockages, the gap
between the pressure plate and the blade drum
can be increased. To do this, turn the adjustment
switch (5) to bring the blade drum to the reverse
pressure plate must be adjusted back again.
DANGER! Risk of injury!
Even when the product is
box
DANGER! Risk of injury!
The product may only be put
faults can be found. If a part is
before the product is used
again.
Check to make sure the product is in a safe
– Check to make sure that the feed hopper is
empty.
– When feeding material into the feed hopper
never stand on a higher surface than the product.
INSTALL COLLECTION BOX
8
