Please contact service department directly if you
cannot eliminate the error by yourself. Please
remember that repairs carried out by non-profes-
sionals will invalidate your warranty claim and
Technical data
The
specified
values are emission values and do not
necessarily represent safe workplace values. Although
safety measures are necessary or not. Factors which
affect
the current immission levels at the workplace,
include the type of room, other sources of noise, e.g.
and risks.
Note:
The product is intended
mains current carrying capacity of
≥100
A per phase and being sup-
with a mains voltage of
230
V. If
required, contact the electricity
company to ensure that the mains
current carrying capacity at the
power grid is adequate for con-
Error/Fault
The motor does not work.
No power supply?
Check the cable, plug, and
the fuse.
manner.
Pressure plate is not adjusted
correctly?
Adjust the pressure plate.
Material to be cut is not
pulled in.
Blade drum is in reverse?
Switch it off, switch the
Use wood to push through,
or dry branches and twigs.
Blade drum is blocked?
Eliminate the blockage.
mechanism been triggered?
Remove all chipping material
Cause
Remedy
40
41
www.Deuba24online.de
www.Deuba24online.de
and the product has cooled
down.
Cleaning the product
Careful handling and regular cleaning ensure that
•Remove loose dirt with a brush.
•Wipe the tool with a damp cloth.
•Never spray the product with water or expose
to water.
•Never use cleaning
fluids
or solvents for
cleaning. This may irreversibly damage the
chem-icals.
•When dispatching, try to use the original
packaging, if possible.
DANGER! Risk of injury!
Unprofessional repairs may
mean that your product will no
longer operate safely. This
endangers you and your envi-
ronment.
Figure 4
The pressure plate is set at the factory. Adjust-
ment is only required when it is worn or, if need
the fact that material is only squashed and
you can hear minor grinding noises.
8
– The pressure plate has been adjusted.
CAUTION!
Device
damage!
-
sure plate too far will cause
unnecessary wear.
Replacing the pressure plate
DANGER! Risk of injury!
Switch the product
off
and pull
the power plug before replac-
ing the pressure plate. Wait
product has cooled down.
Figure 5
– Undo the four screws
(15)
and remove the
– Replace the pressure plate (16).
produc
t and secure using screws (15).
Cleaning and maintenance
DANGER! Risk of injury!
Switch
off
the product and
disconnect from power before
all cleaning and maintenance
Model
Nominal voltage
Capacity
Protection class
Protection rating
Idle revolutions
Maximum cutting
diameter
DBHC003
230-240 V ~
P40 : 2800W
II
IPX4
60 min
-1
44 mm
In many cases, small defects can lead to a
these yourself. Please consult the following table
money.
Guaranteed sound
power level.
94 dB(A)
Sound pressure level at
the user's place.
79.1db(A) K=3
Measured sound power
level
9
1.7
dB(A) K=2.
67
dB(A)
Weight
20.8 Kg
14
14
