Attach a canopy short bar (G) to the canopy
frame (F). For each hole, from upside insert a
medium bolt (Nb) through the bracket of the
short bar (G), the canopy frame (F), a small
metal washer (Ne), and secure with a nut (Nf).
Tighten all bolts and nuts. Repeat procedure for
the remaining three canopy short bars (G).
See Fig. 6. Tighten all bolts and nuts. Cover
with nut caps (Nq).
Place the assembled canopy onto the top of the
assembled leg posts. Make sure each
crossbar (B,C,D,E) is between two edges of the
canopy (L). Line up the holes, for each hole
insert a medium bolt (Nb) through an U shaped
bracket (Nl), canopy short bar (G), a small metal
washer (Ne) and secure with a nut (Nf). Tighten
all bolts and nuts. Slide each tip end of the short
bar (G) into each pocket. See Fig. 8.
NOTE: Short side of the canopy fabric (with
“short” lable) should on the short crossbar (D&E)
4
5
6
G
F
G
G
G
L
G
L
Nf
G
F
Nb
Ne
Nq
Nf
Nl
Nb
G
Ne
short
sho
rt
Nl
Nb
Ne
Nf
F
short
5
Fig. 6
Fig. 7
Fig. 8
long
Attach the canopy fabric (L) to the canopy
frame (F&G) by inserting the bars (G) through
the holes of canopy fabric (L). Then pull down
the wind vent fabric of canopy fabric (L) and
unfold the canopy fabric (L) to the location.
See Fig. 7. NOTE: The middle of the canopy
fabric short side (with “short” lable) towards
middle-length bar of the canopy frame.
