14
SPARK PLUG
THE RECOMMENDED SPARK PLUG FOR THIS UNIT IS L8RTC
(NGK SPARK PLUG TYPE IS RCJ6Y)
1.
Always check the Spark Plug at the beginning of each season
2.
Disconnect Spark Plug Cap and clean any debris or dirt from around the Spark Plug area
3.
Examine the Spark Plug and replace if any of the following have occurred:
a.
P ed Electrodes
b.
Burned Electrodes
c.
Cracked Porcelain
d.
Or Deposits around Spark Plug
4.
A er cleaning or replacing, reseat Spark Plug and ghten securely.... rea ach Spark Plug wire
5.
When reinstalling original Spark Plug, ghten an add onal 1/2 turn
6.
When replacing Spark Plug, adjust Spark Plug Gap to .028" and ghten an add onal 1/8 to 1/4 turn
NOTE:
CARBURETOR
NEVER TAMPER WITH THE FACTORY SETTING OF THE CARBURETOR
TINE REMOVAL AND INSTALLATION
REMOVING TINES
1.
Remove the co er pins from each end of the ne sha
2.
Slide each of the four nes o
ff th
e
INSTALLING TINES
1.
First slide the inside nes onto both ends of the ne sh
Inside nes are stamped with a either a le er "B" or "C"
2.
Slide the outside nes onto the ne sha The outside nes are stamped with either the le er "A" or "D"
3.
The nes should be installed so that they are aligned in a sequence of "A,B.C.D" and should be po oned in that
order from le to right when viewed from the user's po on of the mini cul vator
4.
Make sure the hub collars on both the right and
pair of nes face each other so that there is adequate spacing
between the ne blades (See Fig 3)
5.
Reinsert the co er pins back on each side of the ne sha to lock the nes into place
FIGURE 3
FIGURE 10 FRONT VIEW
A
B
C
D
Hub Collars
Cotter Pin
Cotter Pin
MODEL Y2007
MINI CULTIVATOR AND DETHATHER
A loose Spark Plug can overheat and damage your engine. Over tightening too much could
damage the threads in the cylinder head
