12
OPERATING INSTRUCTIONS
When heater is “ON”:
Burner will display
slight blue flame at the bottom and
strong yellow at the entire top, the color is more visible
at night
.
If only yellow flame is detected
, turn off heater and gas
supply and refer to TROUBLESHOOTING on page 14
.
Visually check burner flames at each use and make sure
flame height matches illustration.
Re-lighting
Note:
For your safety, control knob cannot be turned on without first depressing control knob in off
position and then rotating to on.
1. Turn gas control knob to off.
2. Wait at least 5 minutes to let gas dissipate before attempting to re-light burner.
3. Repeat “Lighting” steps 2 and 3.
Turning Off
1. Rotate gas control knob to “OFF” position. Note: Burner will likely make a slight popping
sound when extinguished.
2. Disconnect LP-gas tank after use.
Rotate LP-gas tank to horizontal position, unscrew it counterclockwise until it is loose.
Store the LP-gas tank in a proper location.
3. Close door on housing assembly.
Note:
After use, some discoloration of the emitter screen is normal.
2
Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning of oils
used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30
minutes. The heater should NOT produce thick black smoke.
CAUTION
