- 22 -
Note:
The above data is adapted to power cord
≤
10 meters from the power
supply .If power cord is
﹥
10 meters away, the wire diameter must be
increased. The signal cable can be extended to 50 meters at most.
3-
Installation instructions and requirements
The swimming pool heater must be installed by a professional. The Public is
not qualified to install by themselves for health and safety reasons.
A. Installation
1) The swimming pool heater should be installed in a place with good
ventilation;
2) The frame must be fixed by bolts (M10) to a concrete foundation or brackets.
The concrete foundation must be solid and fast; the bracket must be strong and
treated against rust.
3) Please don’t place objects that might block air flow in front of or behind the
Heat Pump. The Heat Pump must stand at least 50 cm from any structure or
obstacle otherwise the efficiency of the heater will be reduced or even stopped.
4) The machine needs a circulation pump (supplied by the user). The
recommended pump flow: refer to Technical Specs, Max. lift
≥
10m.
5) When the machine is running, there will be condensation water discharged
from the bottom of the unit and should go to drain. Please hold the drainage
nozzle (accessory) into the hole and clip it well, and then connect a pipe to
drain the condensation water out.
Ｂ．
Wiring
1) Connect to the appropriate power supply; the voltage should comply with
the rated voltage of the products.
2) Earth the machine.
3) Wiring must be handled by a professional technician according to the
circuit diagram.
4) Set the Earth-leakage protector according to the local code for wiring
