- 26 -
2.
Trial
A
.
The user must “Start the Pump before the Heat Pump, And Turn off the Heat
Pump before the Pump”, or the Heat Pump will be damaged;
B
.
The user should start the pump, making sure the water pressure is correct;
set the desired temperature on the thermostat, and then switch on the power
supply.
C
.
In order to protect the swimming pool heater, the Heat Pump is equipped
with a time lag starting function, when starting the Heat Pump, the blower
will run 1 minute before the compressor;
D
.
After the swimming pool heater starts up, check for any abnormal noise
from the Heat Pump.
VIII.
Be Careful
1
. Attention
A. To set the desired temperature in order to get comfortable water temperature;
this will avoid overheating or overcooling;
B. Please don’t stack objects that can block air flow near intake or outlet area,
the Heat Pump’s efficiency may be reduced or even stopped;
C. Please don’t put hands into the outlet of the swimming pool heater, and
don’t remove the screen of the fan at any time;
D. If there are suspect conditions such as noise, smell, smoke and electrical
leakage, please switch off the machine immediately and contact the local
dealer. Don’t try to repair it yourself;
E. Do not use or stock combustible gas or liquid such as thinners, paint and
fuel near the Heat Pump to avoid fire;
F. In order to optimize the heating effect, please install heat preservation
insulation on pipes between swimming pool and the heater. When the Heat
Pump is working please use a recommended cover on the swimming pool
to avoid heat loss through evaporation;
G . The Heat Pump should be placed
≤
10m of the swimming pool, or the
heating effect of the heater cannot be ensured;