9
9. Setting the Watering Data
Note :
The control unit
0
of the water timer can be removed (Fig. B).
This allows you to select the watering program somewhere other than
where the water timer is to be used.
9.1 Setting the watering cycle
You can determine how often your garden should be watered by turning
the
Frequency
knob
2
:
– every 8, 12 or 24 hours
(8 h, 12 h, 24 h)
or
– every 2nd, 3rd or 7th day
(2
nd
, 3
rd
, 7
th
)
Note :
Intermediate positions are not possible.
9.2 Starting time and watering time
1. Turn the
Run Time
control knob
3
to
Reset.
2. Then set the
Run Time
control knob
3
to the required watering time:
1, 2, 3, 4, 5, 6, 8, 10, 15, 30, 60, 90 or 120 minutes.
Important !
After 5 seconds the time you have set is accepted.
This is signalled acoustically by a double beep.
3. The double beep also indicates that the current time has been accepted
as the starting time for future watering programs. The future watering
starting time can be delayed by an hour each time you press
Start
Time
▲
. The
Start Time
▲
must be activated before the double beep.
Note :
The water timer beeps every time you press the key correctly
to confirm you have delayed the time by one hour.
Important ! Start Time
▲
is only active for a max. of 5 seconds after
the last time you press the key. It is then no longer possible to change
the starting time. This is signalled by a double beep.
The watering starting time can only be deleted by turning the knob
to
Reset.
9.3 Examples
Current time: 9:00 am.
The watering program should run as follows:
Example a)
Every day at 9:00 for 10 minutes.
Example b)
3 x a day (= every 8 hours) for 2 minutes. at 10:00,
at 18:00 and at 2:00.
Example c)
Every 3 days at 16:00 for 60 minutes.
Summary of Contents for 1806
Page 3: ......
