7
6
9
0
2
A
Connecting the Turbotrimmer :
Setting the Turbotrimmer
to the working position :
8
7
A
C
B
D
E
12
GB
Risk of injury !
3. Assembly
1. Turn over the Turbotrimmer and
stand it on the rubber buffer of
the handle.
2. Fit the cover
1
on the cutting
head
2
and guide the cutting
filament
3
through the opening
in the cover.
3. Secure the cover
1
using the
two screws
4
.
4. Push the plant guard
5
onto
the cutting head
2
until you
hear it snap into place.
The plant guard keeps plants you
do not want to trim away from the
cutting filament.
4. Operation
Risk of injury if the Turbotrimmer does not switch off when
you release the start button.
V
Never bypass the safety devices (by binding the start
button to the handle, for example).
1. Push the extension cable
6
into
the cable lock
7
on the handle
8
.
2. Plug the plug
9
of the Turbo-
trimmer into the socket
0
of the
extension cable.
Working position :
Position the additional handle
A
so that the cutting head
2
is
tilted slightly forward when you hold the Turbotrimmer in the
working position.
1. Unscrew the tightening nut
B
,
move the additional handle
A
to the correct position and tighten
the nut
B
by hand.
Only for classicCut plus :
2. Unscrew the adjusting nut
C
,
set the additional handle
A
to
the correct angle and tighten
the adjusting nut
C
by hand.
3. Unscrew the tightening nut
D
,
adjust the handle
E
to the
correct length and tighten the
nut
D
by hand.
Mounting the cover
and plant guard :
5
2
3
4
1
