Storage :
Disposal :
(in accordance with
RL 2002 / 96 / EC)
15
GB
5. Unwind the filament
3
(with classicCut plus
the lower filament) approximately 10 cm
and thread it through the eye
O
of the
plastic ring
N
. If necessary, loosen the
filament beforehand using a screwdriver.
The filament
3
may stand out max. 2 cm
over the knife
P
.
6.
Only for classicCut plus :
unwind the
upper filament
3
a approximately 10 cm
and fit it into the notch
Q
of the filament
cassette.
7. Pull the plastic ring
N
back over the filament cassette
G
(with classicCut plus ensure that the upper filament
3
a is
in the slot
R
of the plastic ring).
8. Reinstall the filament cassette as described under 5. Mainte-
nance
“Replacing the filament cassette”.
Only GARDENA Service Centres and authorised specialist
GARDENA dealers may carry out repairs.
Fault Possible
cause
Remedy
The Turbotrimmer
Filament worn or too short.
v
Lengthen the filament –
no longer cuts.
see 4. Operation
“Filament
feed (Tip mechanism for
automatic filament feed )”.
Filament cassette empty.
v
Replace the filament cassette
– see 5. Maintenance
“Replacing the filament
cassette” ).
Filament drawn into the
v
Pull the filament out of the
cassette or stuck together.
filament cassette (see above).
If you have any other problems please contact the GARDENA Customer Service.
7. Storage
The Turbotrimmer must be stored out of the reach of children.
v
Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommended storage :
We recommend that you hang your Turbotrimmer from the cable
lock. Hanging storage helps avoid unnecessary stress on the
cutting head.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
v
Important: Make sure that the unit is disposed of via your
municipal recycling collection centre.
P
N
3
O
z
3a
Q
R
G
