en
12
1. Lift the chain
h
off the bar
2
in the middle of the bar. The gap should
be approx. 2 – 3 mm.
2. Turn the adjustment screw
j
clockwise when the tensioning of the
chain is too low, or turn the adjustment screw
j
anticlockwise when
the tensioning of the chain is too strong.
3. Start the unit for approx. 10 sec.
4. Check the tensioning of the chain again and re-adjust, if necessary.
6. STORAGE
To put into storage [ Fig. A1 ]:
The product must be stored away from children.
1. Disconnect the mains cable.
2. Clean the unit (see 5. MAINTENANCE) and slide the protective cover
1
onto the bar
2
and close the snap fit
3
.
3. Stow the unit in a dry area where it has protection from frost.
7. TROUBLESHOOTING
DANGER! Risk of injury!
Cut injury when the unit starts accidentally.
v
Before you troubleshoot the unit, make sure that the mains
cable is disconnected and the protective cover
1
is slid over
the bar
2
and the snap fit
3
is closed [ Fig. A1 ].
Problem
Possible Cause
Remedy
Unit does not start
Extension cable not connected
or damaged.
v
Connect the extension cable
or if necessary replace it.
Chain blocked.
v
Remove blockage.
Unit can no longer be
stopped
Start button is stuck.
v
Disconnect the mains cable
and loosen start button.
Hedge is not cleanly cut
Chain dull or damaged.
v
Replace chain.
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.
8. TECHNICAL DATA
Telescopic pruner
Unit
Value (Art. 8868)
Motor power consumption
W
720
Mains voltage /
Mains frequency
V / Hz
230 / 50
Motor power consumption
m/s
13
Bar length
cm
20
Chain type
px
90
Oil tank volume
ml
100
Range of extension of
telescopic tube
cm
0 – 45
Weight (approx.)
kg
3.9
Sound pressure level L
pA
1)
Uncertainty k
pA
dB (A)
89
3.0
Sound power level L
WA
1)
Uncertainty k
WA
dB (A)
102
3.0
Hand / arm vibration a
vhw
2)
m/s
2
1.5 ± 1.5
Measuring process complying with:
1)
DIN EN ISO 22868
2)
DIN EN ISO 22867
NOTE: The stated vibration emission value has been measured according to
a standardized test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of expo-
sure. The vibration emission value can vary during actual use of the electric power tool.
9. ACCESSORIES
GARDENA Chainsaw Oil
For lubrication of the chain.
Art. 6006
GARDENA Replacement
Chain and Bar
Chain and bar for replacement.
Art. 4048
GARDENA Replacement Chain
Chain for replacement.
Art. 4049
10. SERVICE
Please contact the address on the back page.
11. DISPOSAL
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
IMPORTANT!
v
Dispose of the product through or via your municipal recycling
collection centre.
