USER MANUAL FOR GB-S3.1 WOOD CHIPPER
5
RECOMMISSIONING AFTER STORAGE
Ensure machine is stable.
Remove all guards and check all fasteners. If necessary,
retighten as described within this manual.
Ensure feed hopper is free from foreign objects e.g. tools
and clothing.
Check fuel within engine and top up accordingly.
Inspect all internal parts e.g. blade system, taper locks and
shaft keyways.
Inspect cutting blades to confirm they are sharp and
suitable for use.
Undertake electrical diagnostic continuity check, to
confirm circuit is complete.
Re-lubricate all grease pipes. Remove pipes and bleed
the system prior to use, if necessary.
Follow daily checks before starting, as described within
this manual.
Start the machine.
Run for 15 minutes at half throttle, prior to any cutting
activity, to clear the combustion engine. Once complete,
bring the machine onto full throttle for a further 5
minutes.
*
Storage fluids should be replaced, DO NOT
USE old stagnate fluids
.
←
*
Fluids within carburetor MUST be drained
out completely (Use 10mm spanner or cross
driver to unscrew the bolt on the bottom of
carburetor, screw and tighten the nut after
draining).
SAFE TRANSPORTATION
GB-S3.1 wood chipper may be transported as a unit or with the feed hopper removed.
Take care when loading the machine.
Strap the chipper down firmly before beginning a journey(do not use feed hopper handles to strap down machine).
Ensure no debris or water is trapped in the rotor housing that may spill during transit.
Turn the fuel valve OFF and keep the engine upright.
DELIVERY
All GB-S3.1 wood chippers have a full pre delivery inspection before leaving the factory and are ready to use. Read and understand
this instruction manual before attempting to operate the chipper.
