background image

0633V  Rev 05/14

8589328

Ultrasonic Aroma Oil Diffuser

Create a spa experience at home. The diffuser releases an ultra-fine water mist that disperses the fragrance of your favorite 

essential oil. A color-changing LED light illuminates the frosted glass cover, adding to the restful ambiance. Quiet, energy-efficient and 
safe, with auto shut-off if water level gets too low. Easy-to-use push-button control allows you to customize your experience. Select 
white light, no light, cycled colors or solid color tone. Choose from continuous mist, 15-second mist intervals or no-mist options.

Parts Included

01 

Outer Cover

02 

Inner Cover

03 

Fan Vent

04 

Power Indicator Light

05 

Mist Control Button

06 

Light Control Button

07 

Maximum Water Level Line

08 

Water Tank

09 

LED Light Bulb

10 

Sensor Pole

11 

Ceramic Disk

12 

Electrical Cord

13 

Mist Control Indicator Light

 Assembly

Step 1. 

Plug the Electrical Cord into the bottom of the diffuser. Do not plug it into 

an electrical outlet until Step 3. Place the diffuser on a level surface where you 
intend to use it. To prevent damage to the machine, it's best not to move it after 
adding water (Step 2). 

Step 2.

 Remove the Outer and Inner Covers. Fill the Water Tank with warm tap 

water (70 to 120 degrees F) to the Maximum Water Level Line (Figure 1). The 
Water Tank holds approximately 1/3 cup of water. 

Important:

 Do not use 

distilled or filtered water. These prevent the ultrasonic ionizer from working 
properly. 

Step 3.

 Add 3 to 5 drops of an essential oil to the water in the Water Tank. 

Step 4.

 Plug the Electrical Cord into an electrical outlet. The red Power Indicator 

Light will illuminate. 

Caution: 

Do not tip the machine after filling with water  

(Figure 2). Doing so may cause water to flow into the internal parts of 
the machine, causing damage. If this occurs, unplug and empty the 
Water Tank. Allow it to air dry in a well-ventilated place for three days 
before refilling.

Step 5. 

Put the Inside Cover back onto the diffuser, carefully matching 

the ridge under the cover with the Fan Vent. When properly aligned, 
the Inside Cover will be fully seated in the top of the diffuser. Put the 
Outside Cover in place. 

Operating Instructions on reverse, over please

Parts Diagram

Maximum Water 
Level Line

Figure 1

Figure 2

Reviews: