Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
17
3. When the location screw has entered the location
hole, the under screws securing the clamp plate
can be tightened. Ensure the screws are equally
and firmly secured. (Fig P)
4. Check the clamp is firmly secured to the
upper shaft (11).
5. If you require further adjustment, the lower clamp
plate securing the clamp to the upper shaft (11)
can be fully removed and the clamp rotated
180°. Take note of the screws; there is one long
hex headed screw and one short screw, and they
need to be replaced in the same threaded hole in
the clamp. (Fig Q1/2)
6. Locate the locating screw in one of the location
holes in the upper shaft (11) and replace the
lower clamp plate and the two screws. (Fig R)
IMPORTANT:
Ensure to replace the screws into
the clamp assembly in the same threaded hole.
There is one long screw and one short screw,
so ensure the screws are replaced as they
were removed.
7. Check the clamp if firmly secured to the
upper shaft.
IMPORTANT:
Do NOT loosen both the J handle
clamp plate and the upper shaft j handle clamp
plate. Make the adjustments one at a time
ensuring the other is fully tightened before
attempting the other adjustment.
P.
Q1.
Q2 .
R .
