Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
25
Changing the line only on the Spool and Line Assembly
NOTE:
Always ensure the engine is turned off before undertaking this
assembly.
NOTE:
The spool and line assembly supplied with
this product requires1 length of 2.4mm diameter
nylon cutting line with a length NOT EXCEEDING
2.8 metres long. Do NOT attempt to fit larger
diameter line or length longer than 2.8 metres
as this will prevent the bump feed to operate
correctly.
1. Whilst holding the spool and line assembly (35)
with the bump knob (34) facing upwards, push
in the 2 side outer parts of the assembly in
between where the 2 ribs protrude on
each side.
When pushing in both sides at the same time
the spool cover can be removed. Ensure the
lines protruding from the eyelets are carefully
pulled out when you remove the inner spool.
(Fig. AM)
NOTE:
When removing the spool, there is a
large 1 washer located on each end
of the spring. Do not lose these. (Fig AN)
2. Remove any remaining line in the spool.
3. Prior to fitting the line into the spool and line
assembly (35), the line needs to be prepared.
Take a 2.8 metre length of 2.4mm line and halve
it. Inspect each end of each line and ensure the
line has no burrs from being cut.
4. Fold the full length of line in half and place the
half way mark of the line into the notch in the
spool (Fig. AO)
AO.
AM.
AN.
