25cc 4 Stroke Petrol Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №.
YR-HT250 • 08/2016 • 52742
(toll free)
16
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №.
YR-HT250 • 08/2016 • 52742
25cc 4 Stroke Petrol Hedge Trimmer
3. Clean the dipstick (17) with a clean rag, and with the hedge trimmer still
standing vertical, enter the dipstick (17) until the thread on the dipstick
(17) makes contact with the thread on the hedge trimmer. DO NOT
thread in. Hold the dipstick (17) in place for a few seconds and then read
the oil level on the dipstick (17).
4. If the oil level is close or below the low level mark on the dipstick (17)
(Fig F), top up the oil to just below the thread entry.
5. When the oil level is correct, replace the dipstick (17) and tighten firmly in
a clockwise direction
IMPORTANT:
Ensure the hedge trimmer is vertical and not leaning to
one side when adding or checking the oil level. Do Not over fill.
Fuelling
IMPORTANT:
Fuel goes off after about 3-4 months. If you find your unit does
not start, first change the fuel in the tank with newly purchased fuel.
WARNING
: Do not refill fuel tank while engine is running or is hot.Move at
least 10m away from the refuelling site before
starting engine.
NOTE.
Do not use fuel that contains ethanol. Use fresh unleaded fuel.
Do not smoke when refuelling or operating the product.
• Be careful not to admit dust, dirt, water or other foreign objects into
the fuel.
• Wipe off spilt fuel thoroughly before starting engine.
• Ensure you DO NOT fuel the unit in close proximity to any open flames, lit
cigarettes, or hot objects.
1. Place the hedge trimmer upright on the ground
or on a sturdy bench and wipe any debris from
around the fuel cap (16).
2. Unscrew the fuel tank cap (16) and pour fresh
unleaded fuel into the tank with the aid of a
funnel or spout (Fig. G)
NOTE:
The fuel tank capacity is 450mL. Be careful
not to spill any mixture. If this happens, wipe the
spill with a clean rag.
G.
