25cc 4 Stroke Petrol Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №.
YR-HT250 • 08/2016 • 52742
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №.
YR-HT250 • 08/2016 • 52742
25cc 4 Stroke Petrol Hedge Trimmer
31
NOTE:
Do not discard unwanted fuel with household waste. It must be
taken to an authorised repository site.
NOTE:
Draining the fuel tank/oil reservoir should be done outdoors.
After the fuel is drained, start the engine. Run the engine at idle until the
unit stops. This will clear the carburettor of fuel. Allow the engine to cool
(approx. 5 minutes).
5. Drain the oil from the oil reservoir (17). After draining the oil from the oil
reservoir either refill with new clean oil or place a tag on the hedge trimmer
handle and write the words “NO OIL”.
6. Using the supplied spark plug spanner (22), remove the spark plug (8).
7. Store the unit in a cool, dry place away from any source of ignition.
8. If disposing of the unit, recycle the unwanted materials instead of disposing
of them as waste. All tools, hoses and packaging should be sorted, taken to
the local recycling centre and disposed of in an environmentally safe way.
9. Check the operation of the On/Off switch (10) controls prior to use or during
maintenance check. (refer to service centre if not operating correctly)
10. Check the condition of the blade for sharpness, cutting edge damage and
binding/ jamming of the blades prior to use or during maintenance check.
11. Check the clutch operation. With motor at idle, blades must not operate and
should only engage when motor is accelerated and stop when the motor is
slowed to idle prior to use or during maintenance check.
Removing a unit from storage
1. Remove spark plug (8).
2. Pull the recoil starter (9) briskly to clear excess oil from the combustion
chamber.
3. Clean and gap the spark plug (8) or install a new spark plug with the proper
gap (Fig Z ).
4. Prepare the unit for operation.
5. Fill the fuel tank (15) with fresh unleaded fuel. Do not use ethanol based fuels
– refer to the section on Fuelling for instructions.
6. Fill the oil reservoir (17) with the required 80mL of SAE 10W/30 4 stroke oil
BEFORE starting – refer to the section on Adding and Checking the oil for
instructions.
