2. Remove the top cover.
3. Disconnect the spark plug boot (Fig. 15/pos. D) from the spark plug (E) by pull-
ing and twisting it simultaneously (Fig. 15).
4. Remove the spark plug using the supplied spark plug wrench (Fig. 1/pos. 22).
DO NOT USE ANY OTHER TOOLS
.
5.
Clean the spark plug with a copper wire brush and refit it, or fit a new spark plug
(Fig. 24). Then replace the top cover.
Carburettor and idling speed settings
m
NOTICE
Settings on the carburettor may only be made by authorised customer service
personnel.
Chain bar maintenance (Fig. 25)
Regular lubrication of the chain bar (guide rail for the chain and teeth) is essential.
The chain bar needs the maintenance described in the following section in order for
the saw to work at an optimum level of performance.
m
NOTICE
The sprocket tip on your new saw has been pre-lubricated at the factory. Failure to
lubricate the guide bar sprocket tip as explained below will result in poor performance
and seizure, voiding the manufacturer's warranty.
To lubricate the sprocket tip
If the saw is used intensively it will be necessary to lubricate the guide bar sprocket
tip (Z2) regularly (once a week).
To do this, first thoroughly clean the 2 mm hole at the tip of the guide bar (Z1), and
then press in a small amount of multi-purpose grease.
Multi-purpose grease and grease guns are available in specialty retail trade.
m
NOTICE
The saw chain does not have to be removed in order to lubricate the sprocket tip of
the chain bar. Lubrication is possible during work, with the engine switched off.
Petrol chainsaw 41cc
Maintenance and servicing
AFTER SALES SUPPORT
45
00800 4003 4003
aldi.service.uk@scheppach.com
MODEL: CSP41 PRODUCT CODE: 64055 04/2017
