Gardenline GDGS12G, User Manual

Operation

19

Inserting and removing the retaining claw

Prior to inserting or removing the retaining claw 

2

, the saw blade 

1

 must first be 

removed. 

1. Ensure that the battery 

9

 is not inserted.

2. In order to insert the retaining claw, press the locking button for the retaining claw 

6

.

3. Position the retaining claw over the saw shoe 

3

 and insert the retaining claw 

into the receiving slot (see 

Fig. B

). 

4. Release the locking button for the retaining claw.
5. Check whether the retaining claw is securely positioned.
6. In order to remove the retaining claw, press the locking button for the retaining 

claw and pull the retaining claw out of the receiving slot.

Changing the saw blade

1. Ensure that the rechargeable battery 

9

 is not inserted.

2. Open the saw blade holder

  4

 by turning the locking mechanism of the saw 

blade holder 

5

 in an anti-clockwise direction to the stop point and by holding it 

firmly in this position (see 

Fig. C

).

3. If applicable, remove the blade by carefully pulling it out of the receiving slot. In-

sert a saw blade 

1

 into the saw blade receiving slot until it clicks into place.

4. Release the locking mechanism of the saw blade holder so that it automatically 

rotates clockwise, closing the saw blade holder.

5. Check whether the saw blade is firmly positioned and that the locking mechanism of 

the saw blade receiving slot can not be turned any further in a clockwise direction.

If you change the saw blade after use, remove the sawdust from the 

saw blade holder beforehand.

Operation

WARNING!

Risk of injury!

Improper handling may result in severe injury. 

− Read and take note of the safety instructions at the beginning of this user 

manual before commencing work.

− Hold the saw firmly on both handles during operation.