11
AFTER SALES SUPPORT:
au.ikramogatec@logwin-logistics.com
MODEL:
SPS01-26TRB2
1300-720-985
AUS
04/2017
PRODUCT CODE: 40510
Setting the idling speed
If the cutter continued running during idling, the idling
speed must be corrected.
1. Allow the motor to warm up for 3–5 minutes (low
speeds!).
2. Turn the adjustment screw (C):
Clockwise idling speed is increased (+) Anticlockwise
idling speed is reduced (–).
C
Contact the manufacturer if the cutter continues run-
ning despite being at idling speed.
In such a case, do not continue to work with the hedge
trimmer!
Cleaning or replacing the air filter
Clean the air filter regularly of dust and dirt, in order to pre-
vent:
-
loss of performance
-
difficulties starting the tool
-
excessive fuel consumption.
22
21
Clean the air filter about every 8 operating hours, or even
more often in particularly dusty conditions.
1. Set the start lever (choke) (21) to
so that no dirt gets
into the carburettor.
2. Remove the air filter cover (19).
3. Remove the air filter (22) from the foam.
4. Wash out the air filter in lukewarm, soapy water.
Do not blow out the dirt, there is a risk of injuries to
the eyes!
5. Clean inside the air filter with a paintbrush.
6. Allow the air filter to dry out properly and reinsert it.
7. Refit the air filter cover.
Change the air filter regularly.
If the air filter is damaged, it must be replaced before
starting work.
Cleaning or replacing the petrol filter
Check the petrol filter (9) as necessary. A dirty petrol filter
hinders the supply of fuel.
Open the petrol cap (10) and pull the petrol filter through
the opening with a wire hook.
-
Light dirt - pull out the petrol filter from the fuel line and
clean the filter in naphtha
-
Heavy dirt - replace the petrol filter
Changing or inspecting the spark plug
Do not touch the spark plug (18) or the spark plug connector
(17) while the motor is running. High voltage! Risk of burning
when the motor is hot. Wear protective gloves!
Check the spark plug and the separation of the electrodes
regularly. To do so, proceed as follows:
1. Pull the spark plug connector out of the spark plug.
2. Unscrew the spark plug with the supplied spark plug Al-
len key.
The separation between the electrodes should be between
0.6 and 0.7 mm.
Clean the spark plug if it is dirty.
Replace the spark plug:
-
if the insulating body is damaged
-
if there is significant loss of material on the electrodes
-
if the electrodes become very dirty or heavily soiled with
oil
-
each month if the tool is used regularly
Inspecting the spark plug
1. Pull the spark plug connector out of the spark plug.
2. Unscrew the spark plug with the supplied spark plug Al-
len key.
3. Firmly attach the spark plug connector.
4. Push the spark plug against the motor housing with iso-
lated pliers (not in the vicinity of the spark plug hole).
5. Move the ON/OFF switch to the “START“ position.
6. Sharply pull the start cord on the starter handle.
