12
AFTER SALES SUPPORT:
au.ikramogatec@logwin-logistics.com
MODEL:
SPS01-26TRB2
1300-720-985
AUS
04/2017
PRODUCT CODE: 40510
If it is working properly, a spark should be visible between
the electrodes.
Silencer/exhaust opening
Do not retighten the screws on the silencer if the mo-
tor is hot.
1. Check on a regularly basis that the screws (D) in the si-
lencer (7) have not come undone. If they are loose, tight-
en them hand tight.
2. Clean the exhaust opening (E) regularly.
Care
Clean the hedge trimmer carefully after every use, so that it
continues to work properly.
Wear protective gloves when cleaning the cutter!
• Clean the housing with a soft brush or a dry cloth.
Water, solvent and polish may not be used.
• Make sure that the ventilation slots for cooling the motor
remain unobstructed (risk of overheating).
• Clean the cutter regularly with a cloth or brush.
Do not clean the cutter with water, due to the risk of
corrosion.
• Clean and oil all moving parts on a regular basis.
Do not use grease for this purpose!
Use environmen-
tally compatible oil.
MAINTENANCE SCHEDULE
Task
Interval
Adjust the cutter
As necessary
Set the idling speed
As necessary
Tighten the screws on the
silencer
As necessary
Clean or replace the
petrol filter
As necessary
Clean or replace the air
filter
Every 8 operating hours
(more often in dusty
conditions)
Lubricate the gearbox
Every 20 operating hours,
at least once a year
TRANSPORT
Switch the motor off to transport the tool and, once the cut-
ter has come to a standstill, attach the blade cover (26).
Carry the tool by the front hand grip. While doing so, hold
the cutter facing backwards and keep the hot silencer away
from the body.
Only transport the tool in a car, inside the boot or in a sepa-
rate transport area. When doing so, secure the hedge trim-
mer against tipping over, damage and leaking fuel.
STORAGE
• Keep the tool in a dry, locked place, with the blade cover
(26) applied, when it is not being used, and out of the
reach of children.
• Before extended storage, please note the following in or-
der to extend the service life of the hedge trimmer and
guarantee smooth running:
-
Perform thorough cleaning
-
Treat all moving parts with environmentally friendly oil.
Do not use grease for this purpose.
-
Remove the spark plug connector.
-
Slide the blade guide onto the cutter.
-
Fully empty the fuel tank.
Dispose of leftover fuel in an environmentally friendly
manner.
-
Allow the carburettor to run empty.
