FOR YOUR SAFETY
Warning! Switch off before adjusting or
cleaning.
The blades continue to move for a few
seconds after the Machine is switched off.
Caution! Do not touch the moving blades.
BEFORE USE
Charging Procedure
The battery charger supplied matches to the Li-ion
battery installed in the machine. Do not use other
battery chargers.
The Li-ion battery is protected against deep
discharging.
When the battery is empty, the machine is
switched off by means of a protective circuit: The
blade no longer moves and a slight whistling sound
can be heard.
If the On/Off switch is subject
to continued use, the Li-ion
battery can be damaged.
Plug the charger cable male connector (17) into the
charging female connector (7) on the machine and
connect the charger to an electrical socket.
> The charging indicator LED (8) will light up red.
Charging is in progress.
> The machine will warm up during the charging
process. This is normal.
Do not use the machine during the charging
process.
> The charging process is completed (after approx.
4 hours) when the charging indicator LED lights
green.
> After completed charging, disconnect the charging
cable connector (17) at first and then the charger
from the mains.
TELESCOPIC HANDLE
(accessory only or supplied with
“grassshear and telescopic handle”
set)
Fitting telescopic handle
Only use the telescopic handle together with the
grass cutting tool to cut edges on the ground.
> Slide the wheel set (14) on the receiver (9) and fix
it using the clamping screw (15).
> Insert the telescopic handle (19) into the
telescopic holder (16) until it engages with a click.
Adjusting Handle Length
Press the adjusting knob (22).
You can release the adjusting knob while pulling
or pushing the telescopic handle.
The adjusting knob engages in the next position.
Removing the telescopic handle
Press on the unlocking knob (21) and pull the
telescopic handle out of its holder (16).
