Electrical safety
The mains voltage must
correspond to the one marked on the
technical data plate (230V~50Hz). Do
not use other sources of power.
The use of a safety circuit-breaker
is recommended for the power supply
line for an intervention range of 10 to 30
rated mA. Consult a reliable electrician.
Never pass the appliance over the
extension cable that the application is
working, as this could cut the cable.
Mark sure you always know where the
cable is.
Use the special cable holder for the
connection of the extension cable.
Never use the appliance when it is
raining. Try to prevent it from getting
wet or being exposed to humidity. Do
not leave it outside overnight. Do not
cut damp or wet grass.
The power supply cable should be
checked regularly and before using it
each time, make sure the cable is not
damaged or old out. If the cable is not in
good condition, do not use the
appliance; take it to an authorized
service center instead.
Only use an extension cable that is
suitable for outdoor work. Keep it away
from the cutting area, from damp, wet
or oily surfaces or with sharp edges and
away from heat and fuels.
The mobile socket of the extension
cable should be splash proof in
compliance with DIN 57282 and VDE
0282 regulations; the cross-section of
the wire (max. length 75 m) should
be at least 1.5 mm2. Use H07RN-F
harmonized cable.
GUIDELINES FOR USING
EXTENSION CORDS
Make sure the extension cord is in
good condition. When using an
extension cord, be sure to use one that
is heavy enough to carry the current
that your product will draw. An
undersized cord will cause a drop in
line voltage, which will result in loss of
power and overheating.
Make sure your extension cord is
properly wired and in good condition.
Always replace a damaged extension
cord, or have it repaired by a qualified
person before using it. Protect
your extension cords from sharp
objects, excessive heat, and damp or
wet areas.
Before connecting the motor to the
power line, make sure the switch is in
the OFF position and the electric
current is rated the same as the current
stamped on the motor nameplate.
Running at a lower voltage will damage
the motor.
This tool must be grounded while in
use in order to protect the operator
from electric shock.
Pour votre sécurité.
Keep bystanders away !
Always switch off the Electric Hoe
and disconnect the plug from the mains
prior to checking the power cable
for damage, or before cleaning the hoe.
Keep cord away from tools!
