EN © 2020 GARDERNIC
–
All Rights Reserved
2-in-1 verticutter and aerator 1500W
27
INSTALLATION OF THE COMPONENTS OF THE DEVICE
You will need a Philips type screwdriver to tighten certain parts of the device. It
is not included.
Make sure that all screws, nuts and bolts are tightened well before starting
work. This will ensure safe working conditions.
The device is delivered partially disassembled. Before using the device, assemble it,
mount the basket and the pushing handle.
Insert the lower parts of the handle (7) into the holes
in the unit body (A) and secure it with the screws
located at the holes. Make
sure that the hole in the
lower part of the handle is facing outwards to fit the
screw. Then attach the middle parts of the handle (11)
to the lower parts of the handle using the hand nut
(4). Slide the power cord (3) over the upper part of
the holder (12) on the right side of the holder, then
attach the upper part of the holder to the already
fixed middle part of the holder and tighten it with
screws and a hand nut.
Unscrew the Philips screws (A) underneath the safety lock and then detach the lower
part of the safety lock housing (B). Attach the lock to the upper part of the handle (12)
from the top and the lower part of the lock housing from the bottom. Tighten all
elements with previously unscrewed screws.
