Page
28
User Manual
GARDTEC
800 Series
Resetting After An Alarm
Your installation company will have programmed the reset modes for your system so
that it complies to your insurance company and legislation requirements.
Your installation company will have informed you as to the type of reset that your
system is set for.
Before attempting to reset your system ensure that the system is Un-set.
1)
If the system is programmed for any code reset enter a user (followed by YES
if Master or Main code is used), the exit tone will sound and the display will
show for example ' E= '
2)
Enter the code again to abort the setting.
3)
The system is now reset.
Or
If the display shows ' Er ' when you attempt to reset it refer to the
programmed reset mode and take the appropriate action as follows:-
Reset Type
Action
Master Code
Use a Master code to set and abort setting
Engineer Code
Call the installation company.
En Anti-Code
Call the installation company.
Anti-Code
When you try to set the system make a note of
the four digit number given on the display,
call the installation company or central station for
an Anti-Code and proceed as shown from step 4
4)
To reset the system with an Anti-Code enter the number given by the central
station or installation company into the keypad (this may contain the YES &
NO keys).
5)
The system is now reset.
combi.qxd 12/01/99 09:00 Page 28
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
