Page
5
GARDTEC
800 Series
User Manual
Setting The System
1)
With the display showing:-
2)
Enter the User code (followed by YES if
Master or Main type code has been used).
The display will show:-
and a continuous exit tone will sound
(1 2 3 C may not show on Gardtec
800 & 816)
3)
Exit the premises via the authorised exit
route (the exit tone will change if any detectors
are violated during exit)
4)
Once the premises are secure listen that the exit
tone returns to the continuous tone.
5)
Wait until the exit tone finishes before leaving.
Note:
Setting the system with an area code (840 Only) will set only the area
associated with that code.
Note:
Setting an unset system with a cleaner code will set the full system.
Setting & Unsetting the
System via a Keyswitch
One of two types of keyswitch(es) may have been fitted to your system.
Normal
To set the system with a normal keyswitch, insert the key and turn to the ON position
then remove the key. To unset insert the key and turn to the OFF position.
Biased
To set the system with a biased keyswitch, insert the key and turn it then return the key
to the original position and remove. To unset repeat this operation.
< < < < UN-SET > > > >
01 JAN 18 : 58 : 01
EXIT Now ! 1 2 3 C
All Zones ON 15
combi.qxd 12/01/99 09:00 Page 5
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com