Gardner Denver L110 10A V4 Translation Of The Original Operating Instructions Download

Page: 6 / 76

The compressor is only classed as being used for

its intended purpose if the following points are also

observed:

The compressor is used according to these op-

erating instructions.
The working steps and standard operating pro-

cedures of the operator are followed.

Any other use or use beyond this is defined as

non-intended use. The manufacturer is not liable

for any resulting damage. The user alone bears

the risk.
Intended use also includes observation of the op-

erating instructions and adherence to the inspec-

tion and maintenance instructions.

Other conditions

Danger to life and limb of the user or third parties

can arise from use of the compressor; likewise

damage to the compressor or other material can

arise if the compressor:

Is not used as intended.
Is not operated by trained personnel.
Is changed or modified.
The safety instructions are not observed.

Alongside these operating instructions, the follow-

ing apply:

Relevant accident prevention regulation
Generally recognised safety rules
Country-specific conditions

Installation location / installation altitude

The compressor is intended for installation in a

suitable compressor room. The compressor is not

suitable for open-air installation!
The permissible installation altitude of the com-

pressor is limited dependent on the operating

pressure, ambient humidity and ambient tempera-

ture at which it is operated. The permissible instal-

lation altitude is specified for each individual case

by consultation between the customer and Gard-

ner Denver.

Working environment

The illumination in the region of the compressor

must be ≥ 200 lx during normal operation.
The illumination for inspection and repair work

must be ≥ 500 lx.
Ambient temperature for operation: see "Technical

data".

Pressure equipment

For pressure equipment/systems a pressure re-

lief device (safety valve or similar) dimensioned to

match the weakest pressure carrying component

and conforming to the relevant regulations must

be installed in the compressed air network.

1.4

Intentional misuse

Incorrect use and misuse

The following typical reasonably foreseeable mis-

uses (incorrect uses) are classed as contrary to

the intended use:

Compression of gases other than atmospheric

air.
Operation outside the permissible operating

limits, even if the exceeding of the limits is only

temporary or not immediately identifiable.
Operation outside the permissible ambient tem-

peratures.
Extraction of non-atmospheric air (overpres-

sure or vacuum pressure).
Use as a breathing air compressor.
Manipulation of sensor signals.
Signal modification of sensors.
Operation without protection and safety equip-

ment.
Operation with defective, deactivated or ma-

nipulated protection and safety equipment or

safety valves, or operation with other such

safety relevant defects.
Use by private users or users without technical

training.
Operation outside industrial environments.
Non-adherence to maintenance intervals.
Omission of maintenance and repair work.
Incorrect execution of maintenance and repair

work.

Limitations on use

Operation of the compressor is not permitted

outside the permissible ambient temperatures.
above the permitted altitude of the installation

location.
on an insufficiently load-bearing substrate.
in areas with an explosive atmosphere.

1.5

Service

If you have any questions about or problems with

the compressor please contact your responsible

Gardner Denver agency.