SB--7--622 Page 7
Blower
Factory Tested
Discharge
Recommended and
Temperature
Approved Lubricant
_
F
_
C
AEON PD
32
_
0
_
Synthetic Blower Lubricant
100
_
38
_
One Superior Lubricant
275
_
135
_
For
350
_
177
_
All Operating Temperatures
FIGURE 5 -- TEMPERATURE CHART
DRIVE END LUBRICATION
Grease drive end bearings every 500 hours of opera-
tion with a non--corrosive, extreme pressure bearing
grease of the following specification:
Blower
Grease
Discharge Temperature
Specification
Up to 350
_
F (177
_
C)
NLGI Grade 2 EP
If not using AEON PD synthetic blower lubricant, use
oils with rust and oxidation inhibitors, anti-foam addi-
tives and the viscosities listed in FIGURE 6.
AIR FILTERS AND FILTER SILENCERS
Servicing the air filters is one of the
most important maintenance opera-
tions to be performed to insure long
blower life.
Servicing frequency of filter elements is not time
predictable. A differential pressure indicator, with a
continuous gauge reading, should be installed across
the inlet filter. It will tell how much of the service life of
the filter element has been used. It will also eliminate
both premature filter servicing and premature blower
failure due to a plugged filter when the filter pressure
drop is used to establish maintenance points.
In all cases refer to the filter manufacturer’s service
instructions. Due to the many types of filters, it is not
practical to give specific instructions covering all
models.
No matter what type of filter is used,
always make sure all seats, gaskets,
clamps and hose connections on the
filter and inlet line are absolutely air
tight. Each time the filter is serviced,
inspect interior of the blower for dirt.
FIGURE 6 -- LUBRICATION RECOMMENDATION
Blower
Oil
Oil Viscosity
Discharge
Grade
SUS
Temperature
ISO
@ 100
_
F
32
_
F to 100
_
F
100
465
(0
_
C to 38
_
C)
100
_
F to 225
_
F
150
700
(38
_
C to 105
_
C)
225
_
F to 300
_
F
220
1000
(105
_
C to 149
_
C)
Over 300
_
F
*
*
(149
_
C)
* The oil viscosity must be 70 SUS minimum at discharge temperature minus 50
_
F.
Summary of Contents for LEGEND GAF P Series
