SB--7--622 Page 17
FIGURE 17
FIGURE 15, page 16). After the headplate has
been removed, detach the puller plate.
12. Remove the two drive end bearings (14) from the
drive headplate (24) using a ball peen hammer
and punch (see FIGURE 16, page 16).
Exercise care not to damage the
headplate bearing bores when remov-
ing bearings.
13. Remove the drive end spacers (33), (34) and (41).
The grease seals (15) can now be driven out of the
drive headplate with hammer and punch (see
FIGURE 16, page 16). Discard the seals as they
will not be reused. Replace grease seals each
time the headplate is removed.
Seals and bearings should be re-
placed during overhaul as a matter of
service policy.
14. Remove the four cap screws (10) which fasten
each bearing retainer (12) to the gear headplate.
15. Attach fabricated puller plate to the gear head-
plate using the tapped holes used to secure the
bearing retainers.
16. Install a gear puller to one of the shafts and attach
the puller arms to the fabricated plate (see
FIGURE 17).
17. Push the impeller shaft through the gear head-
plate and remove the impeller assembly (23) (see
FIGURE 17). Remove the other impeller assem-
bly following the same procedure.
18. Remove mounting foot (17) from the gear head-
plate by removing 4 capscrews (16).
19. Remove the cap screws (21) securing the gear
headplate to the impeller case. Located near each
dowel pin on the headplate is a threaded hole. In-
sert a 3/8--16 UNC capscrew into each of the
threaded holes. Tighten the screws evenly until
the headplate separates from the impeller case.
20. Remove the two gear end bearings (14) from the
gear headplate (18) as done in step 12.
21. Remove the bearing seal spacers (33) and oil
seals (15) from the gear headplate as done in Step
13.
Summary of Contents for LEGEND GAF P Series
