P a g e
|
9
5236.MK2
COMPRESSOR
V14.0, En
3 INSTALLATION
3.1 HANDLING OF UNIT
When using the compressor and motor eyebolts as the slinging attachment, it is essential that a
spreader is used. The lift should always be made vertical, as inclined loadings drastically reduce the
eyebolts' strength. Suitable shackles should be used for this operation.
3.2 LOCATION
Compressor should be installed in a cool, level, well ventilated position, clear of fumes, heat or high
humidity, to ensure efficient performance and also to prevent temperature problems.
RADIATOR SETS
RECOMMENDED INSTALLATION
INCORRECT INSTALLATION
COOLING AIR ENTERS, PASSES
COOLING AIR ENTERS, PASSES
OVER MACHINE AND AS HEATED
OVER MACHINE AND THEN AS
AIR, IT IS EXHAUSTED FROM THE
HEATED AIR, RE-CIRCULATES
MACHINE ENVIRONMENT
IN MACHINE ENVIRONMENT.
It is imperative that the radiator fan works in a cool, clean, direct air flow and that there is a reasonable
air gap around the radiator or it is fixed into a wall. As a large percentage of the compressor cooling
water heat is dissipated via the radiator to the inducted air stream, it is essential that expired cooling
air has an unobstructed passage and exit and does not, under any circumstances, re-circulate in the
immediate compressor environment. If more than one compressor set is installed, each must have its
own direct air flow and in small buildings and enclosures the radiator(s) should be sealed to an outside
wall by means of a duct of a sufficient area for the ventilation required.
Allow sufficient space around the installation to enable safe maintenance working conditions.
Protection from severe weather conditions is desirable.
Summary of Contents for Reavell 5236
