30
<
<
N
N
O
O
T
T
E
E
>
>
)
Any time pressing key followed by
PIN Code
and
OK
key, the screen
returns to
Alarm Off
)
The
Fault DSP
screen has a time-out
for 5 minutes. It will automatically exit
and return to
Alarm Off
screen after 5
minutes.
)
If a sensor is by-passed (Please see
section
Partial Arm mode
, the fault
condition of that sensor will not be
checked.
)
If a sensor tampered or out-of-order
occurs, you can temporarily by-pass it
or permanently remove it.
Arming with Door Opened
z
While you arm the system, if any door was
detected to be open, the Control Panel will
also sound a ding-dong warning sound to
indicate arming is prohibited. The
message
Fault DSP
is displayed in the
middle of the top display row and
alternates at 2-second intervals with the
sensor name that is being triggered.
z
At this moment, you can close the opened
door, after which the fault display will be
cleared automatically and the screen
returns to
Alarm off
. You then can arm
the system again.
z
However, if you want to put the system
into Arm mode with the opened door, it is
still possible by following the Steps
described above to execute
Forced
Arming
.
3.4. Disarm (Alarm off) mode
Disarming the system
To disarm the system
If the system is in either the Away Arm mode or
Home Arm mode (Alarm ON), enter your pin
Code and press
OK
key. If the PIN code is
correct, the Control Panel will sound 2 short
beeps and return to Disarmed mode. The
screen will show.
A l a r m
O
f f
0 6 : 4 3 0 1 J a n
<
<
N
N
O
O
T
T
E
E
>
>
)
When the system is Home Armed,
pressing the
DISARM
button on the
Remote Controller will disarm the
system.
)
When the system is Away Armed,
pressing the
DISARM
button on the
Remote Controller can disarm the
sytem when either an
Entry
device
has been triggered, or when the
Remote Controller Entry Enable
has
been set to
ON
.
3.5. Home Arm Mode
The Home mode allows the home to be Armed
so that no one can get inside without first
Disarming the system, yet the person already
inside the house can move freely without self
triggering the alarm.
<
<
N
N
O
O
T
T
E
E
>
>
)
You can enter the HOME mode only
when the system is in DISARMED
mode.
3.5.1. Entering Home Mode
Step 1.
When the system is in Disarmed mode,
key in your Pin Code then press
OK
key.
Step 2.
Press
T
key to move the cursor
down to select
Home Arm
.
Step 3.
Press
OK
and the screen will display.
T i m e T
o
E
x i t
3 0 s e c
Summary of Contents for CTC-1132
Page 1: ...Installation Programming Operating D D 29 APR 2009...
Page 2: ......
