Garland BULK KEEPER 20V 108 Instruction Manual Download

Page: 29 / 127

English

29/84

Charge the battery only with the charger supplied
with the machine, in a dry place with a temperature
between 0º C and 40º C.
Do not attempt to tamper with or open the battery and
/ or charger.

Do not short circuit the battery and be careful when
handling it so as not to accidentally short circuit it with
conductive elements such as rings, bracelets, keys,
etc. When the battery short-circuits, the temperature
rises and can explode or burn.
Do not change the battery charging polarity or reverse
connections.

Do not attempt to burn or incinerate the battery even
if it is damaged or fully discharged. Do not leave the
battery near a heat source. The battery can explode
with heat or fire causing serious personal and material
damage.

Do not put the battery into the microwave, into the
oven or pressurize it.

Do not use the battery in electrostatic environments.
This battery is sealed and no liquid should ever flow
out of it. If the seal breaks and the liquid touches your
skin, wash thoroughly with soap and water, neutralize
the liquid with a weak acid such as lemon or vinegar,
and go to your medical center urgently. If battery
fluid touches your eyes, flush them thoroughly with
water for 10 minutes and immediately seek medical
attention. If the seal is damaged do not inhale the
vapors produced by the battery as they may cause
irritation. In case of accidental inhalation, breathe
fresh air and seek urgent medical attention.

Do not use the battery if it is deformed.
Always disconnect the battery from the machine
before performing any maintenance on the machine.
Only handle this machine when it is disconnected

2.5. USE AND CARE OF THIS MACHINE

Only cut wood branches. Do not use this

machine for any other purposes not intended. For
example: do not use the scissors to cut plastic
materials, bricks, metals. The use of the scissors
for operations other than those foreseen can cause
dangerous situations.

Use this machine, accessories, supplies, etc. in
accordance with these instructions and as planned,
taking into account the working conditions and
the work to be carried out. Using this machine for
applications other than those intended may cause a
hazardous situation.

The manufacturer will not be liable under any
circumstances for damage caused by improper or
incorrect use of this machine.

Do not force this machine. Use this machine for the
correct application. Using the correct machine for the
type of work to be performed will allow you to work
better and safer.

Do not use this machine if you cannot use it properly
or cannot turn it off because the switch does not
change between “closed” and “open”. Any electrical
machine that cannot be controlled with the switch is
dangerous and must be repaired.

Keep this machine. Check that moving parts are not
misaligned or locked, that there are no broken parts or
other conditions that may affect the operation of this
machine. Whenever this machine is damaged, repair
it before use.
Many accidents are caused by poorly maintained
machines.

Keep cutting instruments sharp and clean. Properly