English
34/104
English
35/104
Perform maintenance frequently as indicated in the
following table:
8.1.1. OIL CHANGE
To do the oil change, the oil must be hot to guarantee
that oil filters out correctly and quickly. If you are going
to change the oil, do so after using the machine if not
you will have to start the machine for a few minutes
prior to changing the oil so as to heat the oil.
Remember that the machine should not be started
with the pump empty (the pump must be filled up with
water).
Oil change:
1. Stop the machine.
2. Place the machine in a horizontal position and in
such a way that the oil drains out into a recipient.
Remember that this machine has a capacity for 0,1
l and therefore the recipient must have at least this
volume.
3. Remove the oil cap.
4. Unscrew the oil emptying screw. Oil will start to
drain out. Do not touch the oil. The oil could be very
hot and could burn you. Oil can also irritate your skin.
5. When oil has stopped draining out, wait a few
minutes more to ensure that the last drops of oil
drain out.
6. Check that the oil emptying screw and its joint are
in perfect state. If not, change them.
7. Screw the emptying oil screw and joint back into
place.
8. Add 0,1 l of new and clean 20W-40.
9. Start the engine for a minute (remember to fill the
machine with water).
10.Check the oil level and if necessary, refill.
Please collect the used up oil in an adequate
recipientfor transporting used up oil and take it to a
recycling centre nearest to you. Do not throw the oil
on the floor or the sewer.
8.1.2. AIR FILTER
The dirt in the air cleaner will cause a reduction in the
performance of the machine.
Check and clean this element. If you notice damage or
alterations to the filter, replace it with a new one.
1. Remove the protective cap from the filter.
2. Remove the filter.
3. You can clean the dust on the exterior of the filter
by hitting it against a hard surface.
4. Clean the filter with soapy water.
5. Rinse the filter with clean water.
6. Dry the filter.
7. Once dry, moisten it with 2 drops of oil (if you wet
the filter with too much oil the machine can’t start).
Action
After ever
y use
After 20 hours work or one
month
Ever
y 50 hours or 3 months
Ever
y 100 hours or 6 months
Ever
y 300 hours or each year
Engine
oil
Check
level
•
Change
•
•
•
Air
filter
Check
•
Clean
•
•
•
Spark
plug
Clean/
adjust
•
•
Deposit
filter
Clean
•
Summary of Contents for GAS 650 QG
Page 102: ...Portugu s 102 104 NOTAS...
Page 104: ......
