18
Part Number 4532292 Rev 3 12/15
Installation
Section 2
COMMISSIONING
Read and understand all installation safety
instructions regarding Electrical and Personal
Protection.
1.
n
Warning
Ensure the control knobs are in the 0 (OFF) position
BEFORE connecting the appliance to the electrical
supply.
0
LOW
HIGH
ON-Position
Any position
where the
White Line is
not pointing
at
0
.
0
LOW
HIGH
OFF-Position
The White
Line is
pointing at
0
.
2. Remove all objects from the griddle plate.
3. Connect the appliance to power supply.
4. Perform an operation test. See instructions in Function
Test on page 18
Function Test
• Read and understand all installation safety
instructions regarding Personal Protection.
• Observe also ALL operation safety
requirements in section
3 Operation
.
1. Turn the control knob to set the temperature to 200°C
or 392°F.
2. The display shows the set temperature followed by a
dot. Example:
or
3. Within 2 seconds, the display changes from the set
temperature (with dot) to the actual temperature
(without dot) of the griddle plate. Example:
4. The griddle plate warms up to the set temperature.
5. As soon as the griddle plate temperature reaches the
set temperature of 200°C or 392°F, turn the control
knob to position
0
(OFF).
6. If the sensors detect high level of residual heat, the
display shows
.
If the residual heat from the griddle plate is low, the
appliance initiates the stand-by mode. When the
system is in the stand-by mode, the dot on the display
blinks once every second.
If the appliance does not function as expected, refer to
section
5 Troubleshooting.
Summary of Contents for GI-SH/GR 3500
Page 31: ......
