English
28/112
English
29/112
6.3.1. FIXING CABLE EXTENSION
Only use cable extensions that are homologated for
outdoor use. The cable section must be at least 1.5
mm
2
and the cable extension should never be longer
than 25 m and must be completely unrolled before
starting to work.
Fix the extension of the tiller by
inserting cable in the hook on
the handle and plug onto the
machine.
6.4. START UP AND
STOPPAGE
Start up of the machine:
Press the security button (1)
and without letting go, press the
On/Off switch (2)
Stoppage of the machine:
Let go of the On/Off switch (2)
6.5. OVERLOAD PROTECTION
This tiller has a security switch that will disconnect
the machine under the following conditions:
• If too much material accumulates on the blades.
• If the material being worked on is too resistant for
the engine capacity.
• If the machine detects a high level of resistance on
the blades.
If you detect that the machine does not start when
the switch is on the On position, the probable cause
will be that the security switch is activated. In this
case disconnect the machine from the mains, check
that the blades are clean and have no elements that
impede the blades from turning and wait 15 minutes
before starting the machine again.
Use this machine only for those purposes for which
it has been designed. The usage of this tiller for any
other purposes is dangerous and can cause damages
to the user and the machine.
Do not get anywhere near to the blades
when the machine is working.
If you lose your balance or fall, let go of the handle
switch immediately.
Do not solely rely on the security measures of this
machine. Use common sense at all times.
Do not use this machine if you are tired, sick, are
taking medicines, or if under the effect of alcohol or
drugs. Lack of sleep and fatigue can cause accidents
and damages.
Do not use this machine at night, with fog or with
reduced visibility. You must see the working area
clearly at all times.
Limit the usage of the machine to 10 minute stints
and rest for a further 10 to 20 minutes in between
sessions.
Never leave this machine unattended.
Do not allow anybody into the working area whilst the
machine is in use. The working perimeter is minimum
15 metres and this is the danger zone.
7. MACHINE USAGE
2
1
Summary of Contents for MULE 341 E
