English
30/112
English
31/112
Clean and remove obstacles from the working area
that could cause accidents prior to use.
Do not use accessories on this machine except those
recommended by the manufacturer as otherwise the
use of non recommended accessories could cause
severe damages to the user and to the machine.
7.1. HOLDING AND GUIDING THE MACHINE
Whilst working, hold the tiller firmly with both hands
on the handles.
Attention! do not use the machine with just one
hand.
Attention! the tiller an jump up or forwards
inadvertently, if the blades hit something hard that
is underground such as big stones, roots or trunks
or if the ground is too hard or if it is frozen.
Always
hold the machine firmly with both hands.
Attention! Always keep an eye as to where the
electric cable is whilst working.
Be careful not to cut
the cable with the blades and ensure that your feet or
any object get tangled with the cable.
7.2. WORKING WITH THE TILLER
Only use this machine to oxygenise soil or for weeding
purposes. Do not use the machine to work in public
areas or to carry out professional agricultural jobs.
Before starting to use the machine check that the
blades are not in contact with any object and that
they can move freely.
Maintain the cable well away from the
cutting elements.
7.2.1. WEEDING
This machine can be used to eliminate weeds from
the surface. To guarantee the best possible results,
the grass must have been recently cut using a brush
cutter or lawnmower so that the tiller can reach the
base of the ground easily.
1. Place the tiller on the work area with the blades on
the floor.
2. Press the On/Off switch.
3. Move the machine slowly over the surface,
pressing lightly but ensuring that the blades do not
enter the soil more than just a few millimetres.
Note: If when weeding, these get tangled on the
blades, stop the machine, disconnect from the mains
and wearing protecting gloves, remove the weeds
from the blades.
7.2.2. OXYGENATING THE SOIL
This machine can move soil to facilitate that it is
well oxygenated. To do this job, previously all grass
and other objects must have been removed from the
surface to be worked on.
To oxygenate soil:
1. Place the tiller on the work area with the blades on
the floor.
2. Press the On/Off switch
3. Press lightly on the tiller so that the blades enter
the soil between 5 and 7 cm.
4. Move the tiller slowly and at an adequate rhythm
so as to allow the tiller to break the soil adequately.
7.2.3. USAGE TIPS
The blades when in movement will pull the machine
forwards. If you counteract this by pulling the machine
back, the blades will penetrate more into the ground.
Summary of Contents for MULE 341 E
