Garland PASTA MAGIC, Installation And Operation Manual

Document #  G_GHD_OM_PASTACUISINE_4607873 – 08/21

 19

OPERATOR TROUBLESHOOTING Continued

Problem

Probable Causes

Corrective Action

BURNERS DO NOT LIGHT

(Main gas supply valve verified to be 

open, the gas valve is verified to be ON, 

and power switch is verified to be ON.)

A.  Ignition module lockout (the 

burners failed to light within 4 

seconds).

        Indicator:  Red trouble light on 

control panel is illuminated.

A.  Turn the controller OFF.  Open the 

control panel by removing the 

screws in the upper corners.  If there 

are two ignition modules, check for 

blown 2-amp fuses and replace as 

necessary.  Close the control panel 

and press the power switch.  Wait at 

least 4 minutes.

B.  Dirty water level sensors.  (If the 

computer does not sense sufficient 

water in the cookpot, it will not 

allow the burners to fire.)

B.  Remove the probe block cover 

and clean the sensors using a 

Scotchbrite™ or similar pad and a 

solution of detergent and water. 

NOTE

: Do not use deliming solution.

C.  Failed controller.

C.  Order replacement controller from 

FASC or distributor.

D.  Failed ignition module or gas valve, 

or broken or loose wiring

C.  Call FASC.

ON UNIT WITH AUTOFILL, COOKPOT 

DID NOT FILL WHEN UNIT WAS 

TURNED ON

(Water supply to unit verified to be ON.)

A.  Dirty water level sensors. 

A.  Remove the probe block cover 

and clean the sensors using a 

Scotchbrite™ or similar pad and a 

solution of detergent and water. 

NOTE

: Do not use deliming solution.

B.  Failed controller.

B.  Order replacement controller from 

FASC or distributor.

C.  Shorted upper water level sensor, 

failed water solenoid valve, or loose/

broken wiring.

C.  Call FASC.

Operator Troubeshooting Guides