Part # P152 Rev 1 (01/13/10)
Page 13
Motor
1 . Open the door .
2 . Remove the oven racks and guides
3 . Remove the two (2) wing screws securing the fan guard
and remove the guard .
4 . Using a hex head wrench loosen the screw securing the
blower wheel to the motor shaft and remove the wheel .
5 . Remove the four (4) screws securing the motor mount
plate to the oven casing back and pull the plate froward
into the oven compartment .
6 . Disconnect the motor wire connections (note which
wires connect to which) and replace faulty motor .
7 . Reassemble in reverse order .
REPLACEMENT OF PARTS continued
TROUBLE SHOOTING
NOTE: Servicing must be carried out by competent persons in accordance with the law .
Griddle Diagnostics
PROBLEM
POSSIBLE CAUSE
SOLUTION
Griddle heating unevenly .
Adjacent griddle is operating at a
different temperature .
Check adjacent griddle section .
Griddle was not thoroughly heated
before using .
Allow more time for griddle to saturate .
Increase warm-up time .
Hot Top or Open Tubular Diagnostics
PROBLEM
POSSIBLE CAUSE
SOLUTION
Top to hot or too cold .
Defective infinite switch .
Replace infinite switch .
Top not heating at all .
Defective element
Replace element .
Defective infinite switch .
Replace Infinite switch .
Sealed Hotplate Diagnostics
PROBLEM
POSSIBLE CAUSE
SOLUTION
Water in pot does not Boil . Water
takes to long to Boil . Switch set to
position ‘6’ .
Pot has irregular bottom .
Use flat bottom pot .
Pot too large for element size .
Use smaller diameter pot .
Pot too small for element size .
Use larger diameter pot .
Element was preheated before pot was
placed on element .
Allow element to cool . Protector will reset .
One element circuit may be defective .
Replace heating element .
Six heat switch may be defective .
Replace 6 heat switch .
