Garland SRW286A, Installation & Operating Instructions Manual

4517957 Rev. 2 (06/05)

Page 19

4.  Break the pipe union connection at the inlet of the 

gas control and the 7/16” union connection located 

at the outlet of the control.

5.  Remove the wires from the connections to the gas 

valve. Be sure to note which wires connect to which 

terminal before doing so.

7.  Replace the control and reassemble in the reverse 

order.

Front Cooling Fan

1.  Remove fastener securing the control compartment 

access panel.

2.  Slide out the control drawer.
3.  Disconnect  the  fan  supply  harness  form  the  unit 

wiring harness.

4.  Remove fasteners retaining the fan and set aside.
5.  Replace the faulty motor.
6.  Reassemble in the reverse order.

Motor

1.  Open the oven doors.
2.  Remove the oven racks and guides.
3.  Remove the two (2) wing screws securing the fan 

guard and remove the guard. 

4.  Using  an  allen  head  wrench  loosen  the  screw 

securing the blower wheel to the motor shaft and 

remove the wheel.

5.  Remove  the  four  (4)  screws  securing  the  motor 

mount plate to the oven casing back and pull the 

plate forward into the oven compartment.

6.  Disconnect the motor wire connections (note which 

wire connects to which) and replace faulty motor.

8.  Reassemble in the reverse order.

REPLACEMENT OF PARTS continued

Ignition Control

1.  Remove  the  fastener  securing  the  control 

compartment access panel.

2.  Slide out the control drawer to access the lamp.
3.  Disconnect  the  supply  wires  to  faulty  ignition 

control (noting the wire connections)

4.  Replace the faulty control.
6.  Reassemble in the reverse order.

Hot Top Ignition Momentary Switch

1.  Remove the griddle grease drawer.
2.  Remove the fasteners securing the front panel.
3.  Remove  the  nuts  securing  the  switch  box  to  the 

front panel.

4.  Disconnect the 2 wires to the switch.
5.   Unscrew the switch from the front panel.
6.  Replace the switch and reassemble in reverse order.

Hot Top Spark Generator

1.  Remove  the  fastener  securing  the  control 

compartment access panel.

2.  Slide out the control drawer to access the generator 

module.

3.  Disconnect the wires to the generator.
4.  Remove fastener retaining the generator.
5.  Replace the faulty module and reassemble in reverse 

order.