English
English
31/96
6.1. STOPPING USAGE OF THE MACHINE
Do not unscrew the high pressure hose straight
after stopping usage.
When not pressing the trigger
of the gun, there will be water from the pump to the
gun which will make unscrewing the connectors
practically impossible straight after use and if you do
manage to unscrew these, there will be danger of
injury.
When stopping use:
1. Place the switch in the ¨o¨ position.
2. Close the winter intake tap.
3. Press the trigger of the gun until water stops
coming out from the tip of the lance.
4. Disconnect the water intake hose of the machine.
5. Connect the machine again by placing the switch
in the ¨1¨ position.
6. Press the trigger of the gun again so that all the
water inside the machine empties. This only lasts
a few seconds. Do not maintain the trigger pressed
further as you could work in dry conditions and
damage the pump of the machine.
7. Disconnect the machine again by placing the
switch in the ¨o¨ position.
8. Disconnect the battery from the machine.
6.2. BATTERY CHARGE
The supply voltage and current must comply with the
indications on the charger’s nameplate.
Before using the battery for the first time, charge it for
at least 1 hour.
To charge the battery, plug the charger into the mains,
the led will light up red. Put the battery in the charger,
the led will turn green and start blinking. The charger
LED will turn from flashing green to green when the
battery is fully charged. When the battery is charged,
remove it from the charger. If you leave the battery
in the charger and it is fully charged, the charger will
automatically turn off after 2 hours, the green LED
still on.
The charging time for a fully discharged battery is 2.5
hours.
If you insert the battery into the charger and the
led starts blinking red, it means that your battery is
damaged or that the battery does not correspond to
this charger.
Recharge the battery when you notice that the power
of your machine decreases. Avoid using the machine
until the battery is fully discharged.
Charge button
Battery charge indicators
Grades:
- The battery will require 2 or 3 complete charge
discharge cycles to reach its maximum energy storage
capacity.
- This battery does not have a memory effect so it is
not necessary to fully discharge it before recharging it.
Summary of Contents for ULTIMATE KEEPER 20V 140
Page 19: ...Espa ol 19 84...
Page 37: ...English 37 96...
Page 92: ...Portugu s 92 96 NOTAS...
Page 94: ......
